Nortec MH SERIES User Manual download pdf (Page 11)

10-00

Page 7

2008-12-03

Info Page: Clean Trg. 1

This page shows the current settings for the time based and externally activated

forced draining/box cleaning (MHTC Reflow) or the box cleaning (MHTC Flow),

respectively.

Note: Wash = draining with simultaneous box cleaning (MHTC Reflow) or box

cleaning only (MHTC Flow), Drain = draining only.

– Time controlled draining/box cleaning (Timer).

– Actual time of day.

– Point in time of the next draining/cleaning cycle.

– Configured cleaning mode.

– Interval controlled draining/box cleaning (Periodic).

– Configured interval time in hours.

– Remaining time in hours up to the next

draining/cleaning cycle.

– Configured cleaning mode.

– Externally controlled draining/box cleaning

(Demand).

– Actual status of the draining/cleaning demand.

– Configured cleaning mode.

– Clean Trg. 1 deactivated (can appear only with

module MHTC Flow).

Info Page: Clean Trg. 2 (Note: This page is not shown with model MHTC Flow)

– Fill cycle controlled draining (Cycle).

– Number of fill cycles between cleaning/draining

cycles.

– Remaining fill cycles up to the next draining.

– Cleaning mode (Wash= Draining with simultaneous

box cleaning or box cleaning only, Drain= draining

only).

– Conductivity controlled draining/cleaning (µSensor) --

>Option.

– Set conductivity limit value inn µS/cm.

– Actual conductivity value of the water in the tub in

µS/cm.

– Configured cleaning mode.

– Operation-dependent draining deactivated (Off).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Nortec MH SERIES User Manual Page 11